Table of Contents
Advertisement
installation
REGENCY
DIRECT VENT FLEX SYSTEM
®
Horizontal Terminations Only
This venting system, in combination with the HZ33CE-11 Direct Vent Gas Fireplace, have been tested and listed as a direct vent heater system by Warnock Hersey.
The location of the termination cap must conform to the requirements in the "Exterior Vent Terminal Locations" Section .
Regency
Direct Vent Flex Termination Kit (Part # 946-513) includes all the parts needed to install the HZ33CE with a maximum run of 2 feet. If in-
®
stalling the HZ33CE-11 with a continuous vent length of more than 2 ft (.6m) to a maximum of 10 ft. (3.0m) use Kit # 946-515 (4 ft) or 946-516 (10 ft) or see
"Rigid Pipe Venting Systems" Section for alternate venting arrangements.
AstroCap Flex Kits
1
6-7/8" dia. flexible liner (kit length)
2
4" dia. flexible liner (kit length)
3
spring spacers (3)
4
thimble (2)
5
AstroCap termination cap (1)
6
screws (12)
7
tube of Mill Pac (1)
8
plated screws (8)
9
screws #8 x 1-1/2" drill point,
stainless steel (4)
Notes:
1. Liner sections should be continuous without
any joints or seams.
2. Only Flex pipe purchased from Regency
may be used for Flex installations.
Minimum
Rigid Pipe Center-Line
24 |
®
Regency Horizon
HZ33CE-11 Gas Fireplace
®
Minimum
Flex Kit Center-Line
Alternate
Horizontal
Termination
Caps
Wherever necessary due to exter-
nal location of cap, the AstroCap
can be replaced with the FPI Riser
Vent Termination Cap.
Advertisement
Table of Contents
