Installing The Right Control Panel - Dell XC Core XC760 Installation And Service Manual

2. Remove the cable cover away from the system.
3. Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
4. Holding the right control panel and VGA cable assembly, slide the right control panel out of the system.
NOTE: Observe the routing of the cable assembly as you remove the right control panel from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 181. Removing the right control panel

Installing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, remove the air shroud
5. Remove the cooling fan cage
6. Remove the side wall
Steps
1. Align and slide the right control panel into the slot on the system.
2. Route the right control panel cable through the side wall of the system.
3. Align and slide the right control panel cable cover in the slot on the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the right control panel cable and VGA cable to the connectors on the system board.
Safety
Before working inside your
cover.
or remove the GPU air
assembly.
bracket.
instructions.
system.
shroud.
Installing and removing system components 183