Volkswagen Transporter 2016 Workshop Manual page 179

Note
The nut -5- is self-locking and must be renewed each time it is loosened.
♦
Bolts -2- and -4- are micro-encapsulated. They must be renewed each time after loosening.
♦
Before new bolts are installed, the thread of the corresponding nut must be cleaned.
♦
A washer -3- must be used with each screwed connection.
♦
WARNING
Battery must be connected with ignition switched on. If pyro‐
technic components (e.g. airbag, seat belt tensioners) are
repaired incorrectly, they may be accidentally triggered after
the battery is connected. Ensure that nobody is in vehicle when
connecting battery.
– Connect earth wire at battery negative terminal ⇒ Electrical
system; Rep. gr. 27 ; Battery; Disconnecting and connecting
battery .
Note
If airbag warning lamp - K75- indicates a fault following installation, event memory must be read, deleted and
read again ⇒ Vehicle diagnostic tester.
Specified torques
Component
Bolts -2-
Bolts -4-
Nut -5-
General body repairs, interior - Edition 03.2020
Specified torque
8 Nm
5 Nm
8 Nm
Transporter 2016 ➤
8. Curtain airbags
171