Volkswagen Transporter 2016 Workshop Manual page 249

Removing
– Pull D-pillar trim -3- out of mountings in body and out of bead‐
ing of rear lid seal beading.
Installing
Install in reverse order of removal, observing the following:
– Before installing, check retaining clips -1- and clips -2- for
damage and renew if necessary.
– Remove any clips left in the body mountings using wedge -
T10383- , and fit them in the trim for installation.
– Following installation, ensure that trim is positioned in door
seal beading.
General body repairs, interior - Edition 03.2020
Transporter 2016 ➤
5. Interior trims
241