– Remove fastening ring -7-.
– Pull clamping pins -4- out of both spreader rivets -3-.
– Unscrew bolts -5-.
– Release side panel trim -1- from mounting brackets.
– Detach wiring harnesses from side trim.
– Remove side trim -1- from vehicle.
Note
Before installing, check retaining clips -2- and clips -8- for damage and renew if necessary.
♦
After installation, check that trim is completely behind beading of rear lid seal.
♦
Installing
Install in reverse order of removal, observing the following:
General body repairs, interior - Edition 03.2020
Transporter 2016 ➤
6. Luggage compartment trims
261