Volkswagen Transporter 2016 Workshop Manual page 263

Only vehicles with additional inner lock in rear lid
Note
With this level, the "lock cylinder cover of the childproof lock" and the "inner lock trim" must also be removed.
– Carefully push inner lock trim panel upwards, and pull trim
panel off trim.
– Insert two 1 mm drill bits 15 mm deep into apertures of lock
cylinder cover of childproof lock. Push drill bits together, and
pull cover out of mountings.
Caution
Damage to rear lid trim
Trim must be renewed in the event of non-observance.
Please carefully release trim around lid lock first!
– Only loosen towards corners once trim has been released
there.
– Do not simply pull trim down; instead, grip behind trim with
fingers and press against rear lid with thumbs.
– If trim is loose from rear lid lock to corners, detach remainder
of trim.
– Unscrew bolts -3-.
– Hold trim with one hand. Remove pull loop -4- with the other
hand.
– Trim is now completely free and can be removed.
– Release clips -1- which have remained in rear lid using release
lever - T10039- .
Installing
Install in reverse order of removal, observing the following:
Note
Before installing, check clips -1- for damage and renew if neces‐
sary.
Specified torques
Component
Bolts for loop
6.3.2 Removing and installing lower rear lid
trim, Transporter
Note
The removal and installation procedures may have to be modified
slightly depending on model variants.
Removing
General body repairs, interior - Edition 03.2020
Specified torque
4 Nm
Transporter 2016 ➤
6. Luggage compartment trims
255