Table of Contents
Advertisement
Operation
Note: Determine the left and right sides of the
machine from the normal operating position.
Before Operation
Installing the Battery Pack
Important: Operate the battery pack only in
temperatures that are within the appropriate range;
refer to Specifi cations.
1. Make sure that the vents on the battery are
clear of any dust and debris.
2. Lift up the battery compartment lid (Figure
11A).
3. Line up the cavity in the battery pack with the
tongue on the machine and slide the battery
pack into the compartment until it locks into
place (Figure 11B).
4. Close the battery compartment lid (Figure
11C).
Adjusting the Cutting Height
WARNING: Adjusting the cutting height may bring
you into contact with the moving blade, causing
serious injury.
•
Shut off the motor and wait for all moving
parts to stop.
•
Do not put your fi ngers under the housing
when adjusting the cutting height.
There are 7 cutting-height settings from 25 to 70
mm. Adjust the cutting height as desired. Figure 12.
To adjust the cutting height, disengage the lever,
raise or lower the machine, and then engage the
lever. Figure 13.
©2020 - Hayter Limited
Spellbrook, Bishop's Stortford,
Herts, CM23 4BU
Figure 11
The cutting height positions are shown in Figure 13.
1
1.
70.0 mm
2.
62.5 mm
3.
55.0 mm
4.
47.5 mm
13
Figure 12
2 3 4 5
6
7
Figure 13
5.
40.0 mm
6. 32.5 mm
7.
25.0 mm
Printed in China
All Rights Reserved
Advertisement
Table of Contents
