Table of Contents
Advertisement
Use RS-232 (VISCA), RS-422(VISCA)/RS-485 (PELCO P/D) Control via Extension Module.
The Extension Module is required when using RS-232 / RS-422/485 signals with external control devices.
You can use RS-232 port or RS-422/485 port on Extension Module to connect to optional controllers, such as joystick
control keyboard, control PC station, to operate the camera.
To perform pan/tilt and zoom operations using the joystick of the control keyboard, and to perform the Preset operation
using the control buttons.
An application software that supports this unit is needed if you use PC station.
System Configuration
RS232 Connection
1.
Set Bottom Dip Switch SW1-B6 to OFF.
2.
Set Baud Rate on Bottom Dip Switch to the same as Baud Rate setting on the keyboard you are using. (See page 18).
3.
Reboot the camera by turning it Off/On after the Bottom Dip Switch has been set up correctly.
4.
Camera ID address setting (see page 18).
The controller must be VISCA compatible.
5.
Camera does not support Daisy Chain in RS232 control mode.
6.
You can make RS232 connection cable if you have the following applications:
7.
14
Advertisement
Table of Contents
