Advertisement
Getting Prepared
Tools Required for the Installation
Description
T-10 TORX driver (set to 9 in-lbs)
T-20 TORX driver (set to 21 in-lbs)
5/16-in torque wrench (set to 10 in-lbs)
5/16-in torque wrench (set to 21 in-lbs)
1-in torque wrench (set to 72 in-lbs)
About Installing the Upgrade
Products affected
Installation to be performed by
Estimated installation time
Estimated adjustment time
Estimated full instrument calibration time
a. This upgrade is for models with Version 6 or Version 7 synthesizers. Version 7 dual-digital synthesizers (DDS)
instruments have a s/n prefix 6201 and greater or instruments upgraded with N52xxBU-xS7.
b. Add 1.0 hours for N5242B equipped with Option 222 low frequency extension (LFE).
Installation Note N5242-90120
Use a 5/16-in torque wrench set to 10 in-lbs on all cable connections
except the front and rear panel bulkhead connectors and the bias tees and
bias tee combiners. The bias tees and bias tee combiners should be
torqued to 9 in-lbs. And, on the front and rear bulkhead connectors, use a
5/16 inch nutsetter or open end torque wrench set to 21 in-lb.
a
N5242B, N5242B, and N5249B Options 217, 219, 222, or 224
Keysight service center or personnel qualified by Keysight
5 hours
b
1.0 hours (2.0 hours
)
b
6.0 hours (8.0 hours
)
Qty
Part Number
1
N/A
1
N/A
1
N/A
1
N/A
1
N/A
11
Advertisement
