Application Examples; Introduction - Danfoss VLT AQUA Drive FC 202 Installation Manual

Application Examples

6 Application Examples

6.1 Introduction

The examples in this section are intended as a quick
reference for common applications.
•
Parameter settings are the regional default values
unless otherwise indicated (selected in
parameter 0-03 Regional Settings).
•
Parameters associated with the terminals and
6 6
their settings are shown next to the drawings.
•
Required switch settings for analog terminals A53
or A54 are also shown.
NOTICE!
When using the optional STO feature, a jumper wire may
be required between terminal 12 (or 13) and terminal 37
for the frequency converter to operate with factory
default programming values.
NOTICE!
The following examples refer only to the frequency
converter control card (right LCP), not the filter.
60
®
VLT AQUA Drive FC 202 Low Harmonic Drive
6.2 Application Examples
6.2.1 Speed
+24 V
+24 V
D IN
D IN
COM
D IN
D IN
D IN
D IN
D IN
+10 V
A IN
A IN
COM
A OUT
COM
U - I
A53
Table 6.1 Analog Speed Reference (Voltage)
Danfoss A/S © 10/2015 All rights reserved.
Function
FC
Parameter 6-10
12
Terminal 53
13
Low Voltage
18
Parameter 6-11
19
Terminal 53
20
High Voltage
27
29
Parameter 6-14
32
Terminal 53
33
Low Ref./Feedb.
37
Value
Parameter 6-15
50
Terminal 53
+
53
High Ref./
54
Feedb. Value
55
-
* = Default Value
42
-10 - +10V
Notes/comments:
39
D IN 37 is an option.
Parameters
Setting
0.07 V*
10 V*
0 RPM
1500 RPM
MG21B322