Table of Contents
Advertisement
4.13.1.2 SSH
Configure SSH on this page. This page shows the Port Security status. Port Security is a module with no direct configuration.
Configuration comes indirectly from other modules -- the user modules. When a user module has enabled port security on a
port, the port is set up for software-based learning. In this mode, frames from unknown MAC addresses are passed on to the
port security module, which in turn asks all user modules whether to allow this new MAC address to forward or block it. For a
MAC address to be set in the forwarding state, all enabled user modules must unanimously agree on allowing the MAC address
to forward. If only one chooses to block it, it will be blocked until that user module decides otherwise.
The SSH Settings and Information screens in
The page includes the following fields:
Object
• SSH Service
• Login Authentication List
• Enable Authentication List
• Session Timeout
• Password Retry Count
• Silent Time
Buttons
: Click to apply changes.
: Click to disconnect telnet communication.
Figure 4-13-3
and
Figure 4-13-4
Figure 4-13-3: SSH Settings Page Screenshot
Description
Disable or enable SSH service.
Select login authentication list from this drop-down list.
Select enable authentication list from this drop-down list.
Set the session timeout value.
Set the password retry count value.
Set the silent time value.
255
User's Manual of IGS-4215 PoE Series
appear.
Advertisement
Table of Contents
