Mitsubishi Electric GOT 1000 User Manual page 91

8.8 Protective cover for oil
Use of the protective cover for oil improves waterproof property, oil resistance, and chemical resistance of
the GOT.
8.8.1 Applicable protective cover for oil
The following protective covers for oil are applicable to the GT11
Product name
Protective cover for oil GT05-50PCO
8.8.2 Installation procedure
Before attaching protective cover for oil
When the USB environmental protection cover is installed on the GOT,
1
remove the cover.
After removing the cover, put the USB connector protective sticker on the
2
USB connector.
Position the POWER LED frame of the cover to the POWER LED on the
3
GOT front face, and the direction of the cover is decided.
Model
For 5.7" GOT
A protective film is attached on the display area when the GOT is shipped. Make
sure to remove the protective film before attaching the protective cover for oil.
For attaching the protective cover for oil to the GOT already mounted on the control
panel, follow the procedures as below.
• Remove the GOT from the control panel. Make sure to externally shut off all
phases of the power supply and remove all cables from the GOT in
advance.
• Clean dirt off surfaces of the GOT and control panel.
.
Contents
GOT
8.8 Protective cover for oil
8.8.1 Applicable protective cover for oil
Protective Cover For oil
8 - 13
1
2
3
4
5
6
7
8