Mitsubishi Electric GOT 1000 User Manual page 226

(2) Set items on the setting key window screen
The table shown below describes details of the set items mentioned on the preceding page.
No.
1) Net No.
2) Station number
3) CPU No.
4) On/Off setting
5) Device No.
6) Device name
7) T/C set value
8) Word device present value
9) Initial I/O signal of module
10) Initial device number of buffer memory
*1: Indicates CC-Link connection (via G4).
14 - 44
14.2 System Monitor
14.2.27 Information and set items displayed on each setting key window screen
Item
Bus connection
0 to 4: This item must be set only when the system is connected to multiple QCPUs. It is not
necessary when the system is connected to another CPU.
Set "1": On, Set "0": Off
For further information about device numbers and names that can be entered:
[Decimal number]
16-bit (one-word) module: Six digits (including a digit for a sign) are set. (Entry example: -
12345)
32-bit (two-word) module: Ten digits (including a digit for a sign) are set. (Entry example: -
123456789)
[D] displayed in the number entry box indicates that the entry is decimal.
[Hexadecimal number]
16-bit (one-word) module: Four digits are set. (Entry example: H AB12)
32-bit (two-word) module: Eight digits are set. (Entry example: H ABCDE123)
[H] displayed in the number entry box indicates that the entry is hexadecimal.
[Decimal number]
16-bit (one-word) module: Six digits (including a digit for a sign) are set. (Entry example: -
12345)
32-bit (two-word) module: Ten digits (including a digit for a sign) are set. (Entry example: -
123456789)
[D] displayed in the number entry box indicates that the entry is decimal.
[Hexadecimal number]
16-bit (one-word) module: Four digits are set. (Entry example: H AB12)
32-bit (two-word) module: Eight digits are set. (Entry example: H ABCDE123)
[H] displayed in the number entry box indicates that the entry is hexadecimal.
Set the first two digits of the three-digit initial I/O signal of the module.
Set the number in a decimal number.
Description of setting
Direct CPU
connection
FF
GT Designer 2 Version Screen Design Manual
GT Designer 3 Version1 Screen Design Manual (Fundamentals)
Computer link
connection
0
FF: When the
0: When the
1 to 64: When a
CC-Link
connection
1
G4 *
host station
is selected
master
station is
selected
local station
is selected