11.5 Utility Call Key Setting
11.5.1 Utility call key setting function
The key position for calling the main menu of the utility can be specified.
The key position can be specified by one point or two points of 4 corners on the screen.
When the key position is specified by one point, the time to switch to the utility when the key position is kept
pressing can be set.
For default setting, the upper left and upper right corners are specified.
Operation settings by drawing software
11.5.2 Utility call key display operation
Main menu
(
Section 9.3 Utility Display)
Touch [GOT setup].
Set the utility call key at [GOT set up] in [System Environment] of GT Designer2.
When using GT Designer3, execute the settings at [GOT Setup...] of [GOT
Environmental Setting].
When change a part of the setting after downloading the project data, change the
setting by [Display] screen of the GOT.
GT Designer2 Version
GT Designer3 Version1 Screen Design Manual (Fundamentals)
GOT setup
Menu call key
Screen Design Manual
Operation settings
Touch
[Operation].
11.5 Utility Call Key Setting
11.5.1 Utility call key setting function
10
11
12
13
Touch
[Utility call key].
14
15
Touch buttons to set
for the utility call key.
16
11 - 16
9