Usb Environmental Protection Cover; Applicable Usb Environmental Protection Cover; Installing Procedure - Mitsubishi Electric GOT 1000 User Manual

8.6 USB Environmental Protection Cover

The USB environmental protection cover protects the USB connector on the front face of GOT from dust,
water, and oil.
The GOT is installed with the USB environmental protection cover at factory shipment.
Replace when damage and deterioration are caused.
8.6.1

Applicable USB environmental protection cover

The following USB environmental protection cover is applicable for GT11
Product name
USB environmental
protection cover
8.6.2

Installing procedure

Turn the GOT power off.
1
Disconnect the USB cable from the GOT if one is connected.
2
Open the USB environmental protection cover equipped with the GOT
3
and remove the mounting screws.
Remove the old USB environmental protection cover from the GOT to
4
replace it with the new USB environmental protection cover.
Fix the new USB environmental protection cover while fitting its
5
projection to the hole in the GOT, and mount the cover to the GOT, using
the mounting screws.
Tightening torque
Mounting screw A
M3 6 pan head screw
Precautions when the USB environmental protection cover is opened
Model
Environmental protection cover for USB interface on the main unit front
GT11-50UCOV
panel (conforming to IP67)
0.36 to 0.48N•m for both mounting screws A and B
Mounting screw B
Environmental protective structure of USB interface is "IP2X" when the USB
environmental protection cover is opened.
8.6.1 Applicable USB environmental protection cover
.
Contents
USB environmental
protection cover
8.6 USB Environmental Protection Cover
Open.
Mounting screw
Projection
8 - 11
1
2
3
4
5
6
7
8