Hardware
3.7.3
Replacing the Rear Cover
The following is needed:
– A new rear cover.
– A torx T10 screwdriver.
Note:
Make sure you have adequate ESD protection.
E1012, E1022, E1032, E1041, E1043, E1060, E1061, E1062 and
E1063
To replace the rear cover you will need a new rear cover, see the
Available Spare Parts
section.
Then follow the steps below:
1. Power off the operator panel.
2. Follow the instructions
Replacing the Battery
to remove the battery.
3. Remove the rear cover of the operator panel by loosening the 4 torx screws.
ON DIP
1 2 3 4
4 x torx screws
Illustration of E1012 and E1022
4 x torx screws
Illustration of E1032
4 x torx screws
Illustration of E1060/E1061/E1062/E1063
26
Mitsubishi Electric, MA00758A