Programming The Memory Feature; Linking And Unlinking The Remote Keyless Entry Key Fob To Memory; Memory Position Recall; Seats - RAM 2500 2020 Owner's Manual

PROGRAMMING THE MEMORY
FEATURE
To create a new memory profile, perform the following:
1. Place the vehicle's ignition in the ON/RUN position
(do not start the engine).
2. Adjust all memory profile settings to desired prefer-
ences (i.e., driver's seat, outside mirrors, adjustable
pedals (if equipped), and radio station presets).
3. Push and release the set (S) button on the memory
switch.
4. Within five seconds, push and release either of the
memory buttons (1) or (2). The instrument cluster
display will show which memory position has been
set.
NOTE:
Memory profiles can be set without the vehicle in PARK.
LINKING AND UNLINKING THE
REMOTE KEYLESS ENTRY KEY FOB
TO MEMORY
Your key fob can be programmed to recall one of two
saved memory profiles by pushing the unlock button on
the key fob.
NOTE:
Before programming your key fob you must select the
"Personal Settings Linked to Key Fob" feature through
the Uconnect Settings. Refer to "Uconnect Settings" in
"Multimedia" for further information.
To program your key fob, perform the following:
1. Place the vehicle's ignition in the OFF position.
2. Select a desired memory profile, 1 or 2.
NOTE:
If a memory profile has not already been set, refer
to "Programming The Memory Feature" in this sec-
tion for instructions on how to set a memory profile.
3. Once the profile has been recalled, push and
release the set (S) button on the memory switch.
4. Push and release button (1) or (2) accordingly.
"Memory Profile Set" (1 or 2) will display in the
instrument cluster.
5. Push and release the lock button on the key fob
within 10 seconds.
NOTE:
Your key fob can be unlinked from your memory set-
tings by pushing the set (S) button, followed by pushing
the unlock button on the key fob within 10 seconds.

MEMORY POSITION RECALL

NOTE:
The vehicle speed must be lower than 5 mph (8 km/h)
to recall memory positions. If a recall is attempted
when the vehicle speed is greater than 5 mph (8 km/h),
a message will be displayed in the instrument cluster
display.
To recall the memory settings for driver one or two,
push the desired memory button number (1 or 2) or the
unlock button on the key fob linked to the desired
memory position.
A recall can be canceled by pushing any of the memory
buttons during a recall (S, 1, or 2). When a recall is can-
celed, the driver's seat and the adjustable pedals
(if equipped) stop moving. A delay of one second will
occur before another recall can be selected.
GETTING TO KNOW YOUR VEHICLE

SEATS

Seats are a part of the Occupant Restraint system of
the vehicle.
WARNING!
•
It is dangerous to ride in a cargo area, inside or
outside of a vehicle. In a collision, people riding in
these areas are more likely to be seriously injured
or killed.
•
Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts. In a collision, people riding in these areas
are more likely to be seriously injured or killed.
•
Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
MANUAL ADJUSTMENT FRONT
SEAT
Manual Front Seat Forward/Rearward
Adjustment
Both front seats are adjustable forward or rearward.
The manual seat adjustment handle is located under
the seat cushion at the front edge of each seat.
27
2