Table of Contents
Advertisement
78
GETTING TO KNOW YOUR VEHICLE
End Cap Screw Location If Equipped With Tonneau Cover
Cleat Removal (Without Tonneau Cover)
Remove the end cap by pushing upward on the release
button located beneath the end cap while pulling the
cap away from the rail. The cleat can now be removed
by sliding it off the end of the rail.
End Cap Release Button If Not Equipped With Tonneau
Cover
Pull End Cap Away From Rail
EASY-OFF TAILGATE
To simplify mounting of a camper unit with an overhang,
the tailgate can be removed.
NOTE:
The electric connector at the bottom of the tailgate
must be disconnected prior to removing the tailgate.
DISCONNECTING THE REAR
CAMERA AND REMOTE KEYLESS
ENTRY
1. Open the tailgate to access the rear camera or
Remote Keyless Entry connector bracket located on
the rear sill.
Connector Bracket Location
2. Remove the connector bracket from the sill by push-
ing inward in the locking tab.
Locking Tab
3. Disconnect the chassis wiring harness, ensuring the
connector bracket does not fall into the sill.
4. Connect the chassis plug and bracket (provided in
the glove compartment) to the chassis wiring har-
ness and insert the bracket back into the sill.
Advertisement
Table of Contents
