Table of Contents
Advertisement
232
STARTING AND OPERATING
NOTE:
If the vehicle is in 4WD Low, the Forward Facing Cam-
era image will be displayed until the "X" button is
pressed or the ignition is placed in the OFF position. If
the vehicle goes out of 4WD Low, then the regular deac-
tivation conditions listed above are applied.
Trailer Reverse Guidance — If Equipped
The Trailer Reverse Guidance feature assists the driver
in backing up a trailer by providing adjustable camera
views of the trailer and surrounding area. The cameras
are mounted on the side mirrors and the images will be
displayed side-by-side on the touchscreen. Left and
right camera images are swapped and mirrored on the
touchscreen to show the equivalent area behind the
vehicle as though the driver is using the side mirrors.
Activation
The Trailer Reverse Guidance feature can be activated
by pressing the Trailer Reverse Guidance button on the
Backup/Cargo Camera Display.
Deactivation
When the vehicle is shifted out of REVERSE (with cam-
era delay turned on), the camera image will continue to
be displayed for up to 10 seconds, unless the vehicle
speed exceeds 8 mph (13 km/h), the vehicle is shifted
into PARK or the ignition is placed in the OFF position.
There is a touchscreen button "X" to disable the display
of the camera image.
If Trailer Reverse Guidance is selected through manu-
ally activated Surround View, Backup Camera, or Cargo
Camera, the below deactivation conditions apply:
•
The "X" button on the display is pressed
•
The vehicle is shifted into PARK
•
The ignition is placed in the OFF position
•
The vehicle speed is over 8 mph (13 km/h) for
10 seconds
WARNING!
Drivers must be careful when backing up even when
using the Surround View Camera. Always check care-
fully behind your vehicle, and be sure to check for
pedestrians, animals, other vehicles, obstructions, or
blind spots before backing up. You are responsible for
the safety of your surroundings and must continue to
pay attention while backing up. Failure to do so can
result in serious injury or death.
CAUTION!
•
To avoid vehicle damage, Surround View should
only be used as a parking aid. The Surround View
camera is unable to view every obstacle or object
in your drive path.
•
To avoid vehicle damage, the vehicle must be
driven slowly when using Surround View to be able
to stop in time when an obstacle is seen. It is rec-
ommended that the driver look frequently over
his/her shoulder when using Surround View.
NOTE:
If the vehicle is not equipped with a Pickup Box:
•
The bottom wedge of the Top View will be displayed
in black.
•
The Rear Cross Path soft button will be grayed out.
•
The guidelines will not be overlaid on Top View/Rear
View and Full Screen of Backup Camera view.
•
Black video will be displayed for the right side of the
Top and Rear View, and full screen of the Backup
Camera view when the Rear View Camera is not
connected.
AUX CAMERA — IF EQUIPPED
Your vehicle may be equipped with one or two AUX Cam-
eras, which display rearview and side view images from
the trailer on the touchscreen.
Activation
The AUX Camera is activated by first pressing the
Backup Camera, Cargo Camera (if equipped), or Sur-
round View Camera (if equipped) button on the touch-
screen, followed by the AUX button located in the upper
left corner of the rearview display. The AUX camera can
also be activated when the vehicle is in REVERSE by
pressing the AUX button.
If equipped with two AUX Cameras, you can switch
between each camera by pressing the AUX1 or
AUX2 buttons on the Trailer Camera display.
AUX1 Camera Button
AUX2 Camera Button
Deactivation
The AUX Camera is deactivated by pressing the "X" in
the upper right corner of the touchscreen. This will
return the display back to the previously displayed
screen.
Advertisement
Table of Contents
