Eu: Radio Equipment Directive; Usa: Federal Communications Commission (Fcc); Canada: Innovation, Science And Economic Development Canada (Ised); Brazil: National Telecommunications Agency (Anatel) - Xylem FLYGT Pareo DCM 711 Installation, Operation And Maintenance Manual

9 Technical Reference
9.3.2 UL
The supply of the unit is considered to be separated from hazardous voltages according to
UL 61010-1, 3rd ed cl. 6.4 and 6.5 (Reinforced insulation) and is treated as below the limits
of UL 61010-1, 6.3.1 and 6.3.2.
The device is intended to be supplied from an isolated Limited Energy Source UL 61010-1,
rd
3 ed cl. 9.4 or Limited Power Source per UL 61010-1 or Class 2 per NEC.

9.3.3 EU: Radio Equipment Directive

Hereby, Xylem Water Solutions Global Services AB declares that DCM 711 is in compliance
with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at
the following internet address: http:// tpi.xyleminc.com.

9.3.4 USA: Federal Communications Commission (FCC)

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To comply with RF exposure compliance requirements, the antenna must be installed to
provide a separation distance of at least 20 cm from all persons.

9.3.5 Canada: Innovation, Science and Economic Development Canada (ISED)

This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada's license-exempt RSS(s). Operation is subject
to the following two conditions:
• This device may not cause interference.
• This device must accept any interference, including interference that may cause
undesired operation of the device.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with minimum
distance of 20 cm from all persons.

9.3.6 Brazil: National Telecommunications Agency (Anatel)

This product contains the board GainSpan model GS2101MIE, Anatel homologation number
00527-18-02618.
This product contains the board Silicon Labs model BGM111, Anatel homologation number
06028-21-03402.

9.3.7 Mexico: Radio Approvals

The Radio Approvals is for control module with Bluetooth module only.
50 DCM 711 Installation, Operation, and Maintenance Manual