Function Description; Configuration; System Setup Modes; Pareo Mode - Xylem FLYGT Pareo DCM 711 Installation, Operation And Maintenance Manual

Control module
Table of Contents

Advertisement

3 Function Description

3.1 Configuration

Initial configuration
Item
Control box
Control module
Factory reset
When the controller is connected to a new pump, then a factory reset must be made. The
controller must be configured to match the voltage and current of the pump.
Setup Wizard
The Setup Wizard starts automatically at the initial startup, or after a factory reset. It is
available from the user interface and includes all the parameters that are needed for the
setup of a complete system. For more information, see
Settings menu
In the Settings menu of the user interface, it is possible to set all the configurable
parameters. For more information, see
System configuration
It is possible to save the configuration of a unit in the system. The configuration is saved as
a backup file on a USB drive. The backup file is used to restore installed units in the system,
or to configure new units. For more information, see

3.2 System setup modes

3.2.1 Pareo mode

The controller communicates with the pump module that is installed in the junction box of the
pump.
Normal operation
Communication established
DCM 711 Installation, Operation, and Maintenance Manual
Description
The control box is preconfigured for pumps with a
specific voltage and current.
The control module must be configured to match
the voltage and current of the pump. The control
module can be configured with a configuration file
or manually.
• For more information about configuration with a
configuration file, see
configuration file
• For more information about manual
configuration, see
30.
Run the Setup Wizard
Settings
on page 38.
Maintenance
Communication loss
If the controller repeatedly loses the communication
to the pump module, then the Pump communication
failure alarm appears. The status lamp turns yellow
and the pump continues to operate without any
input from the controller.
Some of the functionality is lost, see
on page 12.
3 Function Description
Configuration with a
on page 30.
Manual configuration
on page
on page 24.
on page 27.
Comparison
11

Advertisement

Table of Contents
loading

Table of Contents