Selection Of The Axis Id; Led Indicators - Technosoft iPOS3602 BX-CAN Technical Reference

3.6.2

Selection of the Axis ID

The Hardware Axis ID selection is done through the hex
switch SW1. It contains numbers from 0x0 to 0xF.
Depending on SW1 position, the axis ID will be:
Figure 3.30. SW1 Location
3.6.3

LED indicators

Figure 3.31. LED indicators
Table 3.1 – LED indicators
 Technosoft 2022
LED LED name
no.
1 Drive
Ready
2 Drive Error
33
SW1 AxisID
position
0x0 255
0x1 1
0x2 2
0x3 3
0x4 4
0x5 5
0x6 6
0x7 7
0x8 8
0x9 9
0xA 10
0xB 11
0xC 12
0xD 13
0xE 14
0xF 15
LED Function
color
green Lit after power-on when
the drive
ends. Turned off when an
error occurs.
red Turned on when the drive
detects an error condition
or when OUT2/Error is set
to +Vlog with OUT(2)=0
TML instruction.
iPOS360x BX-CAN Technical Reference
initialization