Table of Contents
Advertisement
LED Octostrip Set MKII 100 cm
08) Press the SETUP button to enter and to toggle between the 2 options below. Once you have chosen
the desired option, do as follows:
09) Once you have adjusted the settings, press the SETUP button to confirm.
3. Master/Slave
With this menu you can set the device as a master or a slave device.
01) Press the MODE button until the display shows
02) The device is now operating in slave mode and will react the same as the master device.
4. DMX-512
With this menu you can set the device's DMX starting address and the desired DMX channel mode.
01) Press the MODE button until the display shows
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to set the desired DMX starting address. The adjustment range is
between
04) Press the SETUP button again to proceed to channel mode settings.
05) Press the UP/DOWN buttons to choose one of the following DMX channel modes:
●
6CH, 8CH, 14CH, 24CH, 26CH, 50CH, 96CH or 112CH (for 50 cm LED strips)
●
6CH, 8CH, 14CH, 24CH, 26CH, 50CH, 192CH or 208CH (for 100 cm LED strips)
06) The displayed DMX channel modes depend on the LED strip length. See 8.1., page 21.
07) Press the SETUP button to confirm.
5. Network Settings
With this menu, you can adjust the device's properties, such as the signal source, IP address, net mask,
net, subnet mask, universe and the MAC address.
01) Press the MODE button until the display shows
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to toggle through the 7 options below.
5.1. Signal Source
With this menu you can select the desired signal source: DMX or ArtNet.
01) Press the UP/DOWN buttons until the display shows
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to choose between DMX or ArtNet.
04) Press the SETUP button to confirm.
If you have chosen ArtNet, press the MODE button until the display shows
the signal to be received properly. Otherwise, the device will not function in ArtNet mode.
5.2. IP Address
With this menu you can set the IP address.
01) Press the UP/DOWN buttons until the display shows
02) Press the SETUP button to open the menu. The display will show
Ordercode: 42232
Program speed (Press the UP/DOWN buttons to increase/decrease program
speed. The adjustment range is between 1-100, from slow to fast.)
Strobe (Press the UP/DOWN buttons to set strobe frequency. The adjustment
range is between 0-99, from OFF to high frequency.)
.
19
.
.
.
.
.
.
, for
Advertisement
Table of Contents
