Dmx Cables; Master/Slave Setup - SHOWTEC Spectral PC 1800Z IP65 User Manual

Spectral PC 1800Z IP65

DMX Cables

Shielded twisted-pair cables with 3-pin/5-pin XLR connectors must be used for reliable DMX connection.
You can purchase DMX cables directly from your Highlite International dealer or make your own cables.
If you use XLR audio cables for DMX data transmission, this may lead to signal degradation and unreliable
operation of the DMX network.
When you make your own DMX cables, make sure that you connect the pins and wires correctly as
shown in Fig. 10.

Master/Slave Setup

The Spectral PC 1800Z IP65 supports master/slave control mode. To connect multiple devices in a
master/slave setup, follow the steps below:
Connect the first device's DMX OUT connector to the second device's DMX IN connector with a
3-pin/5-pin DMX cable. The first connected device in the setup will be automatically recognized as
the master device.
Repeat step 1 to connect all devices as shown in Fig. 11.
Set all subsequent devices in the setup as slave devices. See 6.6.4 Run Mode on page 24 for more
information.
Connect a DMX terminator (120 Ω resistor) to the DMX OUT connector of the last device in the setup.
Product code: 43553
17
Fig. 10
Fig. 11