OSEE GoStream Deck User Manual page 80

Panel Layout and Device Features
◼ Record Macro
Macro is a record which a sequence of transitions between several video sources.
The corresponding macro button which is in the process of recording will flash to
indicate the progress.
The macro will only record the changes during the recording process. For
example, if you want a 3:00 second transition, and your switcher's transition rate
is already set to 3:00 seconds, you'll need to change the number, then set it back
to 3:00 seconds to record the setting. If not, your desired transition rate will not be
recorded.
For example: Record a 2s long wipe transition from IN1 to Still1 on MEM1 button,
and pause 2s after pressing IN1. By default, the current PGM input is IN1, and
the preview is IN4, and the transition style is WIPE.
The instructions are as below:
Step 1 Select the target macro button
Press the macro button that you want to create your macro, here press MEM1
button, the button is highlighted in flashing white, the recording has started.
Step 2 Set the target program output
Now start preforming the switching actions. Press IN2 button or any other button
except IN1 on the program bus in order to record the final selection of target
program output. Then press IN1, the real target program output before switching.
Step 3 Set a sleep time
Press MENU button on the panel to load the main menu, then set the sleep time
through scrolling the menu knob to select macro→macro→sleep menu item,
and set it to be 2000ms, as shown in Figure 4.1-64:
Figure 4.1-63 Macro Buttons
74