OSEE GoStream Deck User Manual page 31

Button Comment
AUTO Auto Transition
PREV Preview Transition
CUT Cut
FTB Fade to Black
T Bar Manual Fader bar
 Refer to "4.1.3.1 Display Multiview" for details about Multiview display.
GoStream Deck provides the following transition modes, as shown in Figure 4.1-13:
Description
Perform an auto transition.
Press AUTO button to perform the selected effect
transition(MIX/DIP/WIPE)
preview outputs.
You can see the transition process in PGM window
of the multiview display.
Switch to the preview transition mode, the transition
simulation will be displayed in PVW window.
This is very helpful for the operator to verify a mix,
dip or wipe transition by performing it on the preview
output, thus to avoid mistakes on air.
Perform a cut.
Press CUT button to perform an immediate transition
of the program and preview outputs.
Perform a fading to black.
The FTB button will fade the whole program video
output to black, and all layers are faded down
together.
Once the program output has been faded to black,
the FTB button will flash red until it is pressed again.
Fade to black is often used at the start or end of
production.
The program audio will also fade with the video
by enabling the AFV function.
Perform a manual controlled effect transition.
The fader bar is used as an alternative to the AUTO
button and allows the operator to manually control
the effect transition with T bar. The AUTO button
illuminates red for the duration of manual transition.
25
Panel Layout and Device Features
of the program and