OSEE GoStream Deck User Manual page 53

◼ Relative buttons: AUTO button, T bar, signal sources, transition style buttons
and PREV button.
Figure 4.1-37 Buttons for Preview Transition
 Neither the source buttons, nor AUTO button will change during preview transition.
For example, use AUTO button to wipe transition from IN1 to IN2. Currently, IN1
button in program bus is highlighted in red, that is IN1 is on air right now, and IN4
is the preview signal which is highlighted in green in preview bus, the default
transition style is MIX, as shown in Figure 4.1-33:
Figure 4.1-38 Buttons for Preview Transition in Default Status
Here's how to perform a wipe transition as preview transition, the instructions are
as below:
Step 1 Select IN2 on preview bus
Press IN2 on preview bus that you want IN2 to be the program output after
transition, IN2 will change from gray to highlight green, the AUTO button is
highlighted in white by default.
Step 2 Enable Preview transition mode
Panel Layout and Device Features
47