Panel Layout and Device Features
transition, IN2 will change from gray to highlight green, the AUTO button is
highlighted in white by default.
Step 2 Select a transition style and perform auto transition
Press the DIP button to select the dip transition style, then press the AUTO
button to tell the switcher you want to use an automated transition. IN1, IN2 and
AUTO button will be highlighted in red during transition process.
Step 3 Complete Auto Transition
After completer auto transition, IN2 on program bus and IN1 on preview bus are
exchanged, IN2 is highlighted in red, and IN1 is highlighted in green, AUTO
restores to highlight white.
You will see the current and target buttons and AUTO button illuminated red while
you are in the middle of the transition process.
Figure 4.1-34 Auto Transition Steps
44