Switching Sources Using A Cut - OSEE GoStream Deck User Manual

Panel Layout and Device Features
Figure 4.1-27 Crop Splicing Display Example
◼ Width and Color of the Border
Add a border for Source1 and Source2 via Super Source →border1/border2,
you can set its width and color, as shown in Figure 4.1-28:
 Border Width: Set Super Source → border1/border2→ Width to be
0~10%, it will change the border width for Source1 and Source2
simultaneously;
 Border Color: Set Super Source → border1/border2→ Hue/Saturation
/Brightness to assign a color for the border.
 Refer to "5.1.2 Super Source Settings" for details about Super Source.

4.1.3.3 Switching Sources Using a Cut

Using a cut will instantly change from one source to another, you can perform cut by
switching to the target input source button on the program bus directly, or pressing the
CUT button in transition area.
◼ Cut Methods
 Method 1: by program bus
Switching to the target input source button on the program bus directly.
On the program bus, press a program source select button, it will switch this
input on air immediately.
 When using the program bus to cut, it will only change the background signal,
Figure 4.1-28 Border for Splicing Display
40