OSEE GoStream Deck User Manual page 45

Panel Layout and Device Features
the comparison is as shown in Figure 4.1-26:
Figure 4.1-26 Move Splicing Display in Vertical Direction
◼ Crop the Splicing Display
You can change the position and size via the Super Source →mask field.
First, you should set Super Source →mask1/mask2→ Enable to be On to allow
the crop operation, then you can set the crop parameters, they are H Start, V
Start, H End and V End item.
H Start and H End control the crop part in horizontal direction, it will crop the
leftside or rightside of the combination of Source1 and Source2, meanwhile, V
Start and V End control the crop part in vertical direction, it will crop the upside or
down side of the combination of Source1 and Source. Decrease the parameters
to reduce the cut part, and increase the parameters to add the cut part.
Take a splicing display of zoom in style for example, increase mask1 parameters,
the changings in the splicing display are as shown in Figure 4.1-27 labeled in red
arrows and dotted rectangle:
39