OSEE GoStream Deck User Manual page 47

meanwhile the upstream keyer and downstream keyer will maintain status quo.
 Method 2: by CUT button
First, select a target program source on preview bus, this will not change the
current program output. Then, press the CUT button, it will switch the
program and preview outputs immediately.
◼ Relative buttons: CUT button and signal sources buttons
Figure 4.1-29 Buttons for Cut Operation
For example: use CUT button to cut from IN1 to IN2. Currently, IN1 button in
program bus is highlighted in red, that is IN1 is on air right now, and IN4 is
the preview signal which is highlighted in green in preview bus, as shown in
Figure 4.1-30:
Figure 4.1-30 Bus Buttons in Default Status
Here's how to perform a cut, the instructions are as below:
Step 1 Select IN2 on preview bus
Press IN2 on preview bus to choose IN2 as the preview output, that you want IN2
to be the later program output after cut transition in the future. IN2 will change
from gray to highlight green, the CUT button is highlighted in white by default.
The current program output IN1 will remain unchanged.
Step 2 Perform Cut
Select a cut by pressing CUT button, IN1-the current program input source and
Panel Layout and Device Features
41