8.2.14 Setup Camera Parameters; 8.2.15 Command Barcode Format - Leuze electronic DCR 40 Original Operating Instructions

8.2.14 Setup camera parameters

Code Description
Test Mode
Minimum Exposure (per-
cent)
Maximum Exposure (per-
cent)

8.2.15 Command barcode format

The device can receive commands directly through user input, via serial or text and via configuration com-
mand barcodes. This section describes the format of configuration command barcodes.
Header
<SOH>Y<GS><STX>
(%01%59%1D%02)
Multiple commands can be included in one configuration command barcode by separating each command
with <ETX>.
Example: Scanning a barcode generated from %01%59%1d%02SYAZTCG%03SYAUPOG%03%04 will output
all settings of the AZTC and AUPO symbologies.
Configuration command barcodes:
• Configuration command barcodes use the QR code barcode symbology.
• Source files to generate configuration barcodes have a file extension of .CRCCS and an intermediate
file extension of .CRMKR.
• If source files contain comments, the comment should start with two forward slash (//) characters.
• Source files can have only one Primary Category command per line (see chapter 8.1 "Configuration
command architecture").
Examples:
• example.crccs
Contains:
// Hypothetical
// Outputs all settings of symbologies Aztec and Australian Post
// Rev 1 – 6/22/16 – Jackson – Initial Release
• example.crmkr
Contains:
%01%59%1d%02SYAZTCG%03SYAUPOG%03%04
• example.tif
Leuze electronic
Command Format Op-
tions
IM CP S/P/R/ TM
G
IM CP S/P/R/ ME 20
G
IM CP S/P/R/ XE 100
G
Command
String
DCR 40
De- Notes/Examples
fault
Example: IMCPG
0 Minimum Value
Defines the minimum exposure parame-
ter of camera
Valid Range: 0 to Maximum Exposure
percent
Example: IMCPSME20
100 Maximum Value
Valid Range: 0 and Minimum Exposure
to 100 percent
Example: IMCPSXE100
Trailer
<ETX><EOT>
(%03%04)
Configuration control
58