Starting The Sensor Studio Configuration Software - Leuze electronic DCR 40 Original Operating Instructions

6.3 Starting the Sensor Studio configuration software
Prerequisites:
• The device has been mounted (see chapter 4 "Mounting") and connected (see chapter 5 "Electrical
connection") correctly.
• The device is connected to the PC via the RS 232 interface (see chapter 6.2.4 "Connecting device to
PC").
• The Sensor Studio configuration software is installed on the PC (see chapter 6.2 "Installing Sensor Stu-
dio configuration software").
Ä Start the Sensor Studio configuration software by double-clicking the Sensor Studio icon (
The mode selection of the Project Wizard is displayed.
Ä Select the Device selection without communication connection (offline) configuration mode and
click on [Next].
The Project Wizard displays the Device selection list of the configurable devices.
Fig. 6.1: Device selection for scan engine DCR 40
Ä Select DCR 40 in the Device selection and click on [Next].
The device manager (DTM) of the connected DCR 40 starts with the offline view for the Sensor Studio
configuration project.
Ä Establish the online connection to the connected DCR 40.
In the Sensor Studio FDT frame, click on the [Establish connection with device] button (
In the Sensor Studio FDT frame, click on the [Upload parameters to device] button (
Leuze electronic
Configuration and diagnostics software - Sensor Studio
DCR 40
).
).
).
18