Power Mode Parameters - Leuze electronic DCR 40 Original Operating Instructions

Code Description
Public sector & validation
configuration string
Stand Detection
8.2.6

Power mode parameters

Code Description
Get All Power Management
Parameters
Standby Mode Timer
Standby Mode Timer Delay
(ms)
Sleep Mode Timer
Sleep Mode Timer Delay
(ms)
Leuze electronic
Command Format Op-
tions
CD OP S/P/R/ FP
G
CD ST S/P/R/ SE 1
G
CD ST S/P/R/ SD
G
Command Format Op-
tions
PM PM G
PM SB S/P/R/ EN 0
G
PM SB S/P/R/ VA 5000
G
PM SM S/P/R/ EN 0
G
PM SM S/P/R/ VA 3600
G
DCR 40
De- Notes/Examples
fault
Validation & public sector configuration
string
Example: CDOPSFP
0 Disable
Example: CDSTSSE0
1 Enable
Example: CDSTSSE1
Detects when the reader has been
placed in a stand that contains a trigger
magnet and change to Motion Detection
mode.
CDSTSSD100
Stand detect duplicate barcode block
delay in ms
De- Notes/Examples
fault
Returns all power management parame-
ter values in an XML element.
Example: PMPMG
0 Disable Standby Mode Timer
Example: PMSBSEN0
1 Enable Standby Mode Timer
Example: PMSBSEN1
If Standby Mode Timer is enabled, the
device will go into Standby Mode after
this timer has expired.
Valid Range:
Example: PMSBSVA2000
0 Disable Sleep Mode Timer
Example: PMSMSEN0
1 Enable Sleep Mode Timer
Example: PMSMSEN1
The Standby Mode Timer must be en-
abled for the device to go into Sleep
Mode.
If both Standby Mode Timer and Sleep
Mode Timer are enabled, the device will
go into Sleep Mode after this timer has
expired.
Valid Range:
Example: PMSMSVA3600
Configuration control
50