Starting Up The Device - Configuration; Measures To Be Performed Prior To The Initial Commissioning; Starting The Device; Interface - Leuze electronic DCR 40 Original Operating Instructions

7

Starting up the device - Configuration

7.1

Measures to be performed prior to the initial commissioning

NOTICE
Ä Please observe the notices for device arrangement, see chapter 4.1 "Selecting a mounting
location".
Ä If possible, always trigger the scanner with the aid of commands or an external signal trans-
mitter (photoelectric sensor).
Ä Before commissioning, familiarize yourself with the operation and configuration of the de-
vice(s).
Ä Before connecting the supply voltage, recheck all connections and ensure that they have
been properly made.
7.2

Starting the device

7.2.1

Interface

Proper function of the interface can be most easily tested in service operation using the serial interface with
the Sensor Studio configuration software and a notebook computer.
7.2.2

Online commands

Using the online commands, important device functions can be checked, e.g. reading activation.
7.2.3

Problems

If a problem occurs that cannot be rectified even after checking all electrical connections and settings on
the devices and on the host, contact your responsible Leuze electronic subsidiary or Leuze electronic cus-
tomer service, see chapter 11 "Service and support".
7.3

Setting the communication parameters

You have now commissioned the device. Usually, you will have to configure it before you can use it. Using
the configuration options offered in the Sensor Studio or by means of the device DTM, the device can be
individually configured according to your application. For information on the various configuration options,
see chapter 6 "Configuration and diagnostics software - Sensor Studio" or refer to the online help.
It is normally sufficient to set the code type and code length in accordance with the 1D or 2D codes that are
to be read in order to be able to operate the device.
The setting of code type and code length is usually accomplished by using the Sensor Studio configuration
software (see chapter 6 "Configuration and diagnostics software - Sensor Studio").
Leuze electronic
Starting up the device - Configuration
DCR 40 24