Filter Programming; Diagnostic; Commands; Current Flow Rate (Fr) - Pentair FLECK 4600-SXT Installer Manual

Installer Manual Fleck 4600 SXT - Programming
6.6.

Filter programming

To use the valve as a filter, in the master programming mode, set the regeneration mode (RF) to filter
(FLtr). The controller will let set only the steps necessary to the filter mode, which are: regeneration
control type (CT), days override (DO), regeneration time (RT), backwash (BW), rapid rinse (RR), day of
week (Dn) and current day (CD).
6.7.

Diagnostic

Note
If none of the buttons are pushed for 1 minute in the diagnostic mode the controller returns
to Service mode.

6.7.1. Commands

A Press and hold
B Press or
C Press to exit the diagnostic mode at any time.

6.7.2. Current flow rate (FR)

Note
The display is updated every second.
A Current flow rate display (L/min or gpm depending on display format
programmed):

6.7.3. Peak flow rate (PF)

Note
The controller registers the highest flow rate (L/min) since the last regeneration.
B Peak flow rate display:
58 / 98
and for five seconds to enter the diagnostic mode.
to navigate in the diagnostic mode.
Ref. MKT-IM-028 / A - 03.07.2018