Table of Contents
Advertisement
Chapter 10 Advanced Features
3
Click the LAN port where the IP address will be changed.
4
Disable "DHCP" and enter the desired IP address and subnet mask.
5
Under "Network Settings", enter the default gateway and DNS server addresses. If no changes are necessaries,
keep them as is.
6
Click OK.
Notes:
• The default gateway in the "Network Settings" field will only affect LAN port 1; the DNS server addresses will
affect both LAN ports 1 and 2. If you change the DNS server address on either IP address settings page, it will
affect the other LAN port as well.
• Do not set the IP address of the same segment for LAN port 1 and LAN port 2. This may cause unstable network
communication.
• The following IP addresses are reserved and should not be used. If you configure one of them by accident,
initialize all settings by referring to the
Local loopback address: 127.0.0.1, 255.255.255.0
Network address: 0.0.0.0, 255.255.255.0
"Restoring Factory Defaults"
236
section in chapter 10.
Advertisement
Table of Contents
