Table of Contents
Advertisement
Chapter 1 Getting Started
TS5800D, TS5800DN, TS5800DWR
9
1
Power Button ( )
To power on, connect the power cable and wait for 10 seconds, then press the power button. To power off,
press the power button twice.
2
Info LED
If there is a status message, the info LED will light up amber. Check the LCD panel to see the status message.
3
Error LED
If there is an error, the error LED will light up red. Check the LCD panel to see the error message.
4
LAN1 LED
When LAN port 1 is connected, this LED glows green. It blinks when the connection is active.
5
LAN2 LED
When LAN port 2 is connected, this LED glows green. It blinks when the connection is active.
6
LCD Panel
This display shows the status of many TeraStation settings. It also displays errors and messages when available.
7
Display Button
Switches between the different display modes. Also, if the TeraStation is beeping, press this button to stop it.
8
Function Button
Use this button for Direct Copy, dismounting USB devices, rebuilding RAID arrays, and configuring failover.
9
Drive Lock (
)
Open the front panel with the key to replace drives or access the reset button.
10
Reset Button
To shut down and reboot the TeraStation, press and hold the reset button.
11
Status LEDs
Normally, these LEDs blink green when drives are accessed. If a drive fails, its LED will turn red or amber.
1
2 3 4 5
6 7
10
13
15
14
15
8
16
17
18
11
12
12
19
20
21
24
25
Advertisement
Table of Contents
