Table of Contents
Advertisement
Chapter 5 Backup
1
After failover occurs, log in to Settings for the main TeraStation.
If you have configured to synchronize with the UPS device connected to the failed TeraStation, the E10
message will be displayed on the main TeraStation. In such a case, follow the procedure below to change the
UPS settings on the main TeraStation. If you hadn't, skip to the next step.
a. Disconnect the UPS cable from the failed TeraStation and connect it to the main TeraStation.
b. Click Management.
c. Click
d. Click Edit.
e. Select "Sync with UPS connected to this TeraStation" and reconfigure the desired UPS settings.
f. Click OK when completed.
2
Click Backup.
3
Click
to the right of "Failover".
4
Click Edit Failover Status.
5
Click Force Failover to Stop to cancel the failover settings.
6
Shut down this main TeraStation.
to the right of "UPS Sync".
112
Advertisement
Table of Contents
