Table of Contents
Advertisement
Chapter 5 Backup
Code
Description
The drives were not
B105
recognized.
The file systems of the media
B106
cartridge and USB drive are
not supported.
The device files such as "/dev/
B107
null" etc. does not exist.
Replication
Replication copies all data from a share to a share on a different TeraStation. This is an easy way to configure a
reliable system to provide data protection in the event your main TeraStation fails. To configure replication, connect
an Ethernet cable to the LAN port of each TeraStation and follow the procedure below. For best results, use static IP
addresses for connecting both replication TeraStations (source and destination).
Network
Note: Replication source data is copied to the replication destination folder with a differential overwrite. Any data
that is not in the replication source will be overwritten.
The following describes what can be configured as replication sources and replication destinations.
Folders Available as Replication Sources
• Shared folders on this TeraStation (excluding the "info" folder)
• USB drives connected to this TeraStation
Folders Available as Replication Destinations
• Shared folders on this TeraStation (excluding the "info" folder)
• USB drives connected to this TeraStation
Corrective Action
Check that the drives are recognized
properly in Settings. If you configure
the "mediacartridge" or "usbdisk"
folders for the backup source or
destinations, confirm if these folders
exist in the shared folder list.
Check that the media cartridge
and USB drive are formatted to
the compatible file systems. If you
configure the management backup in
the backup job, FAT format cannot be
used for the backup destination.
Restart the TeraStation and try again.
LAN port 1
(Static IP)
Replication Source
LAN port 1
(Static IP)
Replication Destination
102
LAN port 2
(Static IP)
LAN port 2
(Static IP)
*
**
Log Example
-
-
-
Advertisement
Table of Contents
