Angle Adjustment; Color Frame Installation - SHOWTEC ACT Image Spot 50 CW V1 User Manual

ACT Image Spot 50 CW

Angle Adjustment

You can adjust the angle of the device with the adjustment handle (11).
Turn the adjustment handle (11) counterclockwise to loosen it.
Tilt the device to the desired angle (see Fig. 07).
Turn the adjustment handle (11) clockwise to tighten it. Make sure that the device cannot move
freely after the adjustment handle (11) is tightened.

Color Frame Installation

The ACT Image Spot 50 CW is delivered with a color frame. You can insert a color gel or a diffusion filter
into the color frame. To install the color frame, follow the steps below:
01) Push the spring-loaded screw (06) and at the same time lift the color frame clip (07) and flip it
backwards (see Fig. 08).
02) Insert a color gel or a diffusion filter into the color frame.
03) Insert the color frame into the color frame holders (09) (see Fig. 09).
04) Pull the color frame clip (07) downwards to release the spring-loaded screw (06) (see Fig. 10). The
color frame will be locked in position.
05) Secure the color frame to the overhead structure with an appropriate secondary attachment, for
example a safety cable. Put the safety cable through the safety eye (19) of the color frame. See 4.3.
Rigging on page 13 for more information.
Note:
Make sure that the color frame is locked in position with the color frame clip before using the device.
Product code: 34060
Fig. 08 Fig. 09
14
Fig. 07
Fig. 10