ACT Image Spot 50 CW
DMX Address
In this pop-up submenu you can set the DMX starting address of the device.
Press the UP/DOWN buttons to select the starting DMX address of the device. The selection range is
between 1 and 512.
Press the ENTER button to confirm the selection.
DMX Channel Mode
In this pop-up submenu you can select the DMX channel mode.
Press the UP/DOWN buttons to select the DMX channel mode. There are 2 options available:
●
Option 1: 2-channel mode
●
Option 2: 3-channel mode
Press the ENTER button to confirm the selection.
DMX Fail
In this pop-up submenu you can determine the behavior of the device in case there is no DMX signal.
Press the UP/DOWN buttons to select one of the following 3 options:
●
Manually Defined:
●
Hold:
●
Blackout:
Press the ENTER button to confirm the selection.
Product code: 34060
The device will use the manually selected dimmer value. See 6.6.3. Manual
Mode on page 29 for more information.
The device will use the last DMX signal received correctly.
The device will black out the light output.
27