Changing The Gobo - SHOWTEC ACT Image Spot 50 CW V1 User Manual

ACT Image Spot 50 CW

Changing the Gobo

The ACT Image Spot 50 CW has a built-in gobo holder. To change the gobo, follow the steps below (see
Fig. 15, 16 and 18):
Turn the gobo holder screw (02) on top of the gobo holder (03) counterclockwise to loosen it.
Pull the gobo holder (03) out of the device.
Remove the retaining ring from the gobo holder (03) with needle-nose pliers or a similar sharp tool.
Take care not to damage the gobo.
Remove the gobo from the gobo holder (03).
Insert a new gobo into the gobo holder (03). Make sure that the front of the gobo is facing the screw
side of the gobo holder (03).
Reinsert the retaining ring.
Insert the gobo holder (03) back into the device.
Turn the gobo holder screw (02) on top of the gobo holder (03) clockwise to tighten it. Do not
overtighten it.
Product code: 34060
Fig. 16
20
Fig. 15
Fig. 17
Fig. 18