Remote Control - SHOWTEC ACT Image Spot 50 CW V1 User Manual

ACT Image Spot 50 CW

Remote Control

The device can be controlled with an optionally available IR remote control (42704).
DANGER
Do not ingest battery, chemical burn hazard
The remote control contains a coin cell battery. If the coin cell battery is swallowed, it can cause severe
internal burns in just 2 hours and can lead to death.
The battery is already installed in the remote control. It is protected against discharge by a transparent
plastic foil. Remove the plastic foil before using the remote control for the first time.
When replacing the battery, make sure that the polarity is correct. Incorrect polarity may damage the
remote control.
You can control several devices at the same time with the remote control. Make sure that you point the
remote control towards the infrared sensor (10) of the device or group of devices that you want to
control, as shown in Fig. 20. If you point the remote control outside of the range of the sensor(s), the
device(s) will not respond to the remote control.
Note:
When you turn off the device, the next time you turn it on, it will continue to operate in the previously
selected operation mode.
Product code: 34060
32
Fig. 20