Table of Contents
Advertisement
Section 7 - Lubrication and Maintenance
7.2
GENERAL MAINTENANCE INSTRUCTIONS
Prior to performing any service or maintenance on the telehandler, follow the
shut-down procedure on page 4-3 unless otherwise instructed. Ensure telehandler
is level, for proper fluid readings.
• Clean lubrication fittings before lubricating.
• After greasing telehandler, cycle all functions several times to distribute lubricants.
Perform this maintenance procedure without attachment installed.
• Apply a light coating of engine oil to all linkage pivot points.
• Intervals shown are for normal usage and conditions. Adjust intervals for abnormal
usage and conditions.
• Check all lubricant levels when lubricant is cool. For ease of filling hydraulic reservoir,
use a funnel with a hose or flexible tube for best results.
CUT/CRUSH/BURN HAZARD. Do not perform service or maintenance on the machine
with the engine running.
7-2
WARNING
31200938
Advertisement
Table of Contents
