Table of Contents
Advertisement
Transporting a Load
• After engaging the load and resting it against the backrest, tilt the load back to
position it for travel. Travel in accordance with the requirements set forth in Section 1-
General Safety Practices and Section 5 - Attachments & Hitches.
Leveling Procedure
1. Position machine in best location to lift or place load.
2. Apply parking brake and shift transmission to NEUTRAL.
3. Observe level indicator(s) to determine whether machine must be leveled prior to
lifting load.
4. If equipped, level machine with frame level switch (see page 3-26) or outrigger
controls (see page 3-18 or 3-23).
Important things to remember:
• Never raise the boom/attachment more than 1,2 m (4 ft) above ground unless
telehandler is level.
(AUS - Never raise the forks more than 300 mm (11.8 in) above ground surface unless
telehandler is level.)
• The combination of frame leveling and load could cause the telehandler to tip over.
31200938
Section 4 - Operation
OW0540
4-7
Advertisement
Table of Contents
