Info Banner - Strong 9120072370595 User Manual

6.1.2 Channel list
Press OK in viewing mode to display the channel list. In the header section the corresponding name of
the selected channel list will be displayed. Use pq inside the channel list to highlight your channel of
choice and press OK to switch to the highlighted channel.
The channel list is equipped with a filter function to make it easier to find your favourite channels. While
in the channel list, press RED. An alphabet banner will now be displayed. Use pq or P+/P- to select
the first letter or number of the channel you wish to filter for and press OK or t to change to the filtered
list. All channels, beginning with the chosen letter, will now be listed at the left side (ascending order by
channel number). Then use the buttons as usually to select the desired channel. Afterwards the normal
channel list is displayed again. To quickly switch between your preferred channels, use the 9 button to
display the list of Recently watched channels.
The following buttons are available in the channel list and in viewing mode:
TV/R: Toggles between TV and radio channels, in channel list changes the list mode.
LIST:
Opens the satellite list selection in viewing and list mode in case there is more than 1
satellite installed.
FAV:
Displays the favourite list selection in both modes. Details about creating favourite lists
can be found in chapter 7.2.1 TV Channel Manager.
To return to the original respectively to the previous channel list /mode use TV/R or LIST.
6.1.3 Using the CH+/CH- buttons
CH+ or p will switch to a higher channel.
CH- or q will switch a lower channel.
6.1.4 Using the 9 button
In order to quickly switch between your most preferred channels, use 9 to view the list of Recently
watched channels. This list contains up to 30 recently watched channels. As this list is temporary it will be
recreated each time after you switch on your receiver. In the Settings > System Settings menu, the Recent
channel list option can also be set to Off, in this case pressing the 9 button switches between the 2 last
watched channels.

6.2 Info Banner

Any time during viewing mode you can press the INFO button to get info about the current channel and
programme*.
In this state, it is possible to use t u to display channel and programme information about other
channels without switching channels, but however in this mode you can also switch to the selected
channel by pressing OK. Press INFO twice to display detailed programme information of the current
or next programme. For the current programme information use t u to change between the current
and next event information. In the respective programme information, you can use P+/P- to scroll if
applicable. If you press the button a third time, technical details of this channel will be displayed. The
technical information might help you in case of reception or similar problems to see if the channel
provides Audio/Video PIDs and if the signal is of sufficient quality and strength additionally you can find
the Device-ID (Gerätenummer) in this screen. Press INFO or  to close the information.
Settings for the display duration can be set in menu 7.3.2 System Settings.
* Programme information are displayed in case of availability. Availability depends on the broadcast.
11