Table of Contents
Advertisement
Operation
3. 5 Machine operation
General safety instructions
Loader unit operation
Transporting with a full bucket
BA DT05 EN – Edition 2.0 * dt05b340.fm
3
• Never drive up to the edge of a pit from outside – risk of cave-in!
• Do not operate the machine under projecting earth. Stones or the projecting
earth can fall onto the machine.
• When working on roofs of buildings or other structures, these are to be
checked for stability before starting work; The building can collapse, causing
serious injury and damage.
• Do not position the machine directly underneath the workplace during
demolition, otherwise demolished parts can fall onto the machine or the
building can collapse, causing serious injury or damage.
• Operation of the machine by unauthorized personnel is prohibited!
• The hydraulic system of the machine is still pressurized even when the
engine is not running! Release the pressure in the sections of the system
and hydraulic lines which are to be opened before starting setup or repair
work, e.g. fitting/removing an attachment with hydraulic functions.
• Before tilting out the skip next to an excavation, secure the machine with
suitable wheel chocks or other auxiliary means.
• Always watch the material as you tilt out the skip: ensure that the material is
dumped out evenly and does not remain stuck in the skip, otherwise the
machine could tip over.
• Do not dump the load when working on sloping ground.
• Transporting persons or animals in the skip is prohibited.
• When transporting material, actuating the skip and/or the loader unit (option)
is prohibited!
• Always perform precise and smooth control movements, do not perform
abrupt movements.
• Do not get off the machine when it is moving.
• Avoid hazardous work conditions on the job site, do not work in severe
weather and ensure that no one is at risk.
• Transporting persons is prohibited.
The following section describes work operations with the machine
equipped with the loader unit. The loader unit is mainly used for earth-
moving applications, and for loosening, picking up and loading loose
material.
Attention!
No transport of material: the loader unit is designed for loading
loose material only.
Loading loose material is described below
Only load material with the skip tilted in
Operation
3-27
Advertisement
Table of Contents
