Table of Contents
Advertisement
Applications with lifting gear
Trailer
Transportation
Temperature ranges
2. 7 Safety instructions for maintenance
BA DT05 EN – Edition 2.0 * dt05b210.fm
Definition:
Applications with lifting gear are understood as procedures involving rais-
ing, transporting and lowering loads with the help of slings and load-secur-
ing devices (for example ropes, chains). In doing so, the help of persons is
necessary for securing and detaching the load. This applies, for example,
to lifting and lowering pipes, shaft rings or containers.
• No applications with lifting gear!
• Hitching and towing other vehicles is prohibited!
• The machine must be loaded and transported only in accordance with
the Operator's Manual!
• For towing the machine observe the prescribed transport position,
permissible speed and itinerary
• Use only suitable means of transport of appropriate capacity/payload!
• Safely secure the machine on means of transport! Use suitable tie-
down points and load-securing devices.
• The recommissioning procedure must be strictly in accordance with the
Operator's Manual!
The machine can be operated at a maximum temperature of +45°C and a
minimum temperature of -15°C; If the machine is to be used in other tem-
perature ranges (e.g. in tropical temperatures etc.), you must contact the
Wacker Neuson distributor.
Carry out all maintenance and inspection work before storing the machine
for the winter. Then store the machine in a dry place at ambient tempera-
ture (about +15°C). Observe these temperature ranges so as not to affect
the machine's service life.
• Avoid any operational mode that might be prejudicial to safety!
• Observe the adjustment, maintenance and inspection activities and
intervals set forth in the Operator's Manual, including information on the
replacement of parts/partial equipment!
These activities must be performed by technical personnel only.
• The machine may not be serviced, repaired or test-driven by unautho-
rized personnel
• Brief the personnel/the operator before beginning special operations
and maintenance! Appoint a person to supervise the activities!
• In any work concerning the operation, conversion or adjustment of the
machine and its safety-oriented devices, or any work related to mainte-
nance, inspection and repair, observe the start-up and shut-down
procedures set forth in the Operator's Manual, and the information on
maintenance
• If required, secure the maintenance area appropriately!
Safety instructions
2-7
Advertisement
Table of Contents
