Crane-Lifting The Machine - Wacker Neuson DT05 Operator's Manual

Crane-lifting the machine

L2
L1
L1 L2
Fig. 50: Crane-lifting
BA DT05 EN – Edition 2.0 * dt05b330.fm
Safety regulations
• The crane and the lifting gear must have suitable dimensions
• Crane-lifting the machine requires suitable lifting gear
• Secure the machine against unintentional movement!
Danger!
Incorrect crane-lifting of the machine –
Ensure that no one is near the machine!
Have loads fastened and crane operators guided by experi-
enced persons only! The person guiding the crane operator
must be within sight or sound of him.
Ensure that the crane and the lifting gear (cables, chains)
have sufficient lifting capacity!
Raise the machine with an empty skip only.
Stay clear of suspended loads!
It is essential that you read the safety instructions at the
beginning of this chapter and follow any other safety instruc-
tions relevant in your country!
Load the machine as follows:
• Empty the skip and the loader unit
• Lower tipping trailer
• Stop the engine
• Remove the ignition key (model DT05-D).
• Use suitable lifting gear, chains, etc.
Length L1 of the lifting gear on the skip must be at least 2.0 m long
Length L2 of the lifting gear (two cables or chains) on the control
stand must be at least 2.0 m long
• Slowly raise the machine
Accident hazard!
Operation
3-23